Tiger1

Same problem and error message here also. Wrong version will not install on this device.

Just finished hooking up the OEM camera to the Z110BT. Took me 5 hours but most of that was education unwanted, also had to join TIS for wiring/connector help. The Venza has a multifunction display (TFT) up front that the camera is connected to. You just need to splice into 3 wires, 2 for the camera and 1 for the reverse signal. The connector at back of TFT is F1. #14 = Red to Vid + (pin on the rca) #15 = White to Vid - (shield on rca) #2 = Gray to purple/white pioneer harness. P.S. I tried to use pinouts and wire colors from a post in the Tundra forum, but they were differe

I have done the bypass per instructions on this forum, and NO it does not remove the caution screen.

The Venza does have the USB and IPOD 3.5mm plug receptable both in a unit. I have the schematic now and have indentified the plug and pins. I'm a little thick headed on this stuff, but knew you all could help. Thanks. NOW, for my next deal. I have run down the OEM backup camera and will try to splice in an RCA male to plug into the HU. The biggie at the moment, OEM microphone (on the mirror) to a 2.5mm 2 pole plug to go to HU. I can not find the pinout for the Pioneer Mic plug. I assume the tip is MIC + and ring is MIC -, can someone confirm?

I guess I am not explaining this very well. The USB and Ipod PLUG exist already in the 2010 Venza. But I am not able at this point to identify the ends of these pinouts at the OEM HU plug/plugs. I have already done the work for the Pioneer Z110BT and have the pins identified to the plug in at the HU. Would be a simple cut and splice (solder/heat shrink) if I could ID the other ends of the OEMs. Plan B would be to somehow get the wiring behind the USB PLUG port and ID those colors or splice at that point, but that is more disassembly of the console. As it is we have the Pioneer

It was pretty easy to run the Pioneer's cable pinouts, if I can be positive of the OEM end, I will splice into the Pioneer cable and keep the nice neat OEM receptable. Just discovered the TIS site, will get the wiring schematic if possible. Right now I am not even sure of which plug it is. Nothing like a challenge for a retired old guy.

2010 Venza, I installed the Z110BT this saturday (about 10 hours). Everything is good, BUT, I would like to use the stock OEM USB and IPOD plug. I have the pinouts for the USB and Ipod plug and also have the wiring for the Z110BT pinouts. I was unable to positively identify the plug and the pinouts for the OEM Head Unit plug. I think it is the brown 12 pin plug, but I got resistance instead of connituity when testing with OHM meter. Got more than one wire to show as a resistance also, very confused at this point. Does anyone know the wiring schematic for the Toyota Venza OEM USB IP

I have a 2010 Venza with OEM backup camera to front TFT display. Have Z110BT HU and will attempt install this weekend if all my odds and ends get here. Has anyone located and modded the OEM camera for the Venza to the Pioneer? Good info in this thread regardless, thanks.