mrjc

Posted this in wrong forum, but I have a HTC one and Motorola X that have Pioneers App Radio loaded on them. While connected to Bluetooth and also have either phone plugged into a USB cable which is plugged into the back of the radio, The App Radio initially appears to connect then disconnects. A minute or two later will connect, then disconnect. Both phones play music from Bluetooth fine without the App Radio. I did update firmware to 1.06 and also tried factory reset and unhooked battery for a few minutes. The directions/manual elude to the infamous cable required OR a Bluetooth connection a

Hi all, wonder id anyone else see this or maybe I overlooked something. I have a HTC one which is on the approved list for androids. Downloaded the Pioneer AppRadio and the device is register through the radio (I can play music over the Bluetooth and hear phone calls without the appradio. But I have tried factory restore, disconnecting battery, downloaded AppRadio on my Motorola X and same thing. Installed Firmware 1.06 without a problem. Now I DO NOT have the separate harness that plugs into the HDMI port. I do have a USB cable plugged into the back of the radio and am connected via Bluetooth

Gosh, I am Windows 2000 and up MCSE certified and it never occured to me about Windows CE versions. Anyhoooo downloaded that testmode file onto a fresh formatted SD card and it booted into the CE environment. It took a lot longer than previous attempts and my FM radio even played for a minute before it booted into TM. Thanks all!

Well, I did preformed a "clean install" of the map and data enclosed in the new CNSD 200FM box. I did this to force a new data and map load. I wiped the hardrive by using my tried and true testmode and deleting everything then inserting SD card number A and rebooting. All went well and she loaded everything off the "A"card. Total time to reload everything was 40 mins. I rebooted and confirmed the new data and maps were loaded after slecting language and voice. Now none of my tried and true testmode files will boot the unit into testmode. I confirmed the unit can see the SD card by locating POI