b3soul

b3soul Today, 08:51 AM Hello! Im attempting the 2 wire bypass on my z2. I burned the iso file to a cd using cyberlink burning software. When I insert the cd in the z2 drive it says reading cd rom but nothing happens. I pushed map and it just went to the map screen. My hardware screen indicates my ebrake wire is grounded because it says "on". I copied the file back from my disc to the computer successfully so I assume the burn was ok. Am I doing something wrong. How do I get this z2bypass file to update my unit?? Thanks

Oops burning software not biting. Hahah

Hello! Im attempting the 2 wire bypass on my z2. I burned the iso file to a cd using cyberlink biting software. When I insert the cd in the drive it says cd rom inserted but nothing happens. I pushed map and it just went to the map screen. My hardware screen indicates my ebrake wire is grounded because it says "on". I copied the file back from my disc to the computer successfully so I assume the burn was ok. Am I doing something wrong. How do I get this z2bypass file to update my unit?? Thanks

Hello! Im attempting the 2 wire bypass on my z2. I burned the iso file to a cd using cyberlink biting software. When I insert the cd in the drive it says cd rom inserted but nothing happens. I pushed map and it just went to the map screen. My hardware screen indicates my ebrake wire is grounded because it says "on". I copied the file back from my disc to the computer successfully so I assume the burn was ok. Am I doing something wrong. How do I get this z2bypass file to update my unit?? Thanks

thanks...ill let you know how it goes tomorrow

thanks again...sorry to keep bothering you....i cant get the sensor to even read simple hybrid mode....it just says sensor initializing....do i have to disconnect one or both of the bypass wires to get this sensor to initalize?

in addition...i noticed the user manual says i can get simple hybrid mode if it doesn't find a speed signal-this is all i really want..i'm not as concerned about the 3D mode

ok thanks..i noticed before i reset it it said simple hybrid. was this possibly attained by the previous vehicle? i really just want it to somewhere close to where i am....is this not possible without a vss? right now it says im at least 20 miles from where i am...i was reading posts about it working ok(not perfect) without the vss hooked up..why is mine so far off?? is it possible its just taking a long time to update my location?

Hey everybody...im new to this site...thanks for any help in advance...i just installed a z2 in my vehicle and performed the bypass procedure as detailed in this site. After the install my unit thought i was going 187 mph which i assume happened because i was moving it around while the unit was powered up in nav mode. once i mounted the unit i reset the 3d calibration and now i cant get it to initialize..the sensor status says sensor intializing and the unit will not update my current location..in the hardware status my gps antenna says ok and recognizes two satellites and updates the time so