coldranger

I installed my Z2 a month ago and after sometime started to lose sound in the front speakers, either the left or the right especially after going over a bump. Eventually, I lost sound completely from the front. I figured it was a bad wiring job on my part, but today I redid the connections and installed infinity reference components and still have no sound from the front speakers. I’m trying to run my components straight off the Z2 and the rears and factory sub off of factory amp through a PAC OEM-2. I drive a 2006 Nissan Xterra with the Rockfort Fosgate system. Any ideas or sugges

I'm trying to figure out if tapped the right reverse wire or not. In the "connection status" display, the back signal strength says "high." However, it does not change when I move the gearshift into reverse. Is this the correct setup?

Location/Color of the reverse and parking break wires?