lalojamesliz

Yes

I finally installed my new deck and got all the bugs fixed but my lower frequencies on my sub aren't as good as when I had a lc8 and my oem stereo. This version of pioneer stereos don't have a loudness feature and I have the crossover for my sub off. On my amp they are at 25hz and 100hz. I have a noise filter for the engine noise my sub had but it sounded the same without the filter. Same settings on the amp as when I had my oem stereo. Do you guys have any suggestions?

I took care problems I had except for not being able to connect my phone and use the radio apps icon, I don't mind though. Radio reception is perfect now since I connected the antenna blue power wire to the acc wire on my pioneer harness. The noise filter crutchfield sent me took care of the engine noise A couple of small issues, I actually like the loudness feature they removed and my sub doesn't hit as hard on the lower frequencies and my oem stereo did with a audiocontrol LC8. oh well

That's a nice deck but more than I would like to spend right now since I've bought a few other things recently

It's a aftermarket amp. Usually I would blame the amp but if I unplug the rca's, the noise and sound go away. Even when I switch between sources. I also don't like the reversed picture on my backup camera. I really liked this radio too I think I might just get rid of this and buy my previous radio. The avh-8500

The antenna plugged in directly. I need to look again to be sure about the other plug for it. I soldered some wire to the outside of the rca cables connecting them and grounded that to the radio body. I also tapped into the pioneer harness ground and added a wire to it grounding that on a bolt that holds up my vent system near my radio that had good ground. Nothing helped. I tried both usb's and one would say incompatible usb device and the other worked for android auto. My wife has the car so it's hard to remember

Hey guys, I just installed a new 4100nex in my 2014 Toyota avalon and the radio reception is really bad compared to the oem stereo. I bought it from Crutchfield and also bought the harness available that let's me keep my back up camera. I connected the antenna power wire but the reception is still weak. The reverse wire on the harness I bought didn't connect to anything on my cars harness side so I'm wondering if it's the same thing. Can I connect the antenna power wire to a switched 12v power source like the ignition wire on the pioneer harness to fix the reception? Also, I have bad eng

I have the option to buy the square trade 3yr warranty, should I get it or is it a waste? Do these radios ever fail? Well within a few years..... I've had other pioneer radios last years but I've never had a navigation unit like the z140bh.

Hello everyone, so I just bought and received my z140bh that I bought for my 08 Toyota sequoia with the jbl system. I purchased the pac tato to make the z140bh with my factory jbl amp (wife's car) and it only has connections for power,ground,auxiliary,and the dimmer. I'm going to do the bypass but what happens or what do I do with the mute wire if I don't pull it out for the bypass? Thanks guys.