seventy07

Thanks, I know about the red +12V switched, did you install ina an 07 altima?

If you could that would be great if you actually found out exaclty what they had to do to get the controls to operate the SWI. How much did they charge? and did they install the rest of your system? At this point I just want the steering controls, I'd be willing to pay an installer.

yes, I had the black wire grounded the setup the instructions said was as follows: pac red to +12V switched pac black to ground pac white to two steering wheel controls, 1 with 560 ohm resistor, 1 without resistor yes, I think its the blue from the steering wheel that I grounded any other suggestions, I really need to speak with someone who did this in an '07 altima

here are pics of my D3 installed in the factory nav. bezel....

flowtime>>when you get the PAC-SWI PS and if you can install it. let me know, hopefully I will have mine working by then.[/i]

I am trying to hook-up the steering wheel interface to my 07 altima and am having no luck with the interface recognizing the controls. This is my second unit and I can't get it to work with my D3, but specifically the steering wheel controls is the issue with programming. PAC's website says run two wires into the SWI white wire, 1 with a 560 ohm resistor. Run another factory wire to ground and +12V switched. I can get the SWI to the correct version, but that was easy, I just can't get it to recognize the control buttons properly. If someone with experience programming the SWI in an 07 a

I have a D3 in my 07 altima, I can't seem to get the pac-swips programmed. Is there anyone here who has successfully done this and if so what wires did you use from the factory nissan harness? as well as what resistors did you use? I am not sure what wires to try, the directions on pac's website did not work for programming my unit, any suggestions?