USC Justice

Ok, as the title says, I have an X910BT with 3.0205 firmware on it. I just updated and upgraded my Z110BT to use the updated firmware and maps as the Z130 is using. I really like the revised interface and the updated maps. Problem is I have no idea how to do this with the X910 in my wife's pathfinder. I tried to do it the same way, but it doesn't recognize the firmware and contents of the SD card. Any help would be most appreciated.

Perhaps it has been covered, but I didn't see it with the search feature. I have both the CD-I200 and the CD-IB100ii. Which one is better to use with my D3? What are the real differences between the two? Thanks in advance. Donald

I need the VSS wire for a 96 Nissan Maxima SE with the Bose factory system, and also the closest place to tap into the reverse lights rather than running a wire all the way back to the tail of the car. Thanks in advance.

Very new to all of this, however here is what I have: 95 Nissan 240SX AVH P6600DVD head unit AVIC 90DVD Nav system with the CNDV 50MT discs The AVIC is mounted in the rear of the car under the back dash. The wiring is taken care of and I have been driving the car with it in for about a week and a half. It is in simple hybrid mode. under the calibration screen it showed a total of 144 pulses on the speed. I have reset this and driven 20 miles with it showing zero. The wire that is tapped into at the ECM located at the passenger kick panel is Yellow witha Green stripe. I h