Scooter_Alberta

Everything was working fine prior to update. I pulled the dash off after the update to perform the 2 wire ground. Put everything back together, and everything is unlocked (drove about 40+ miles), but when I go into the config screen it reads 0 for the speed pulse (when moving) and excessive vibration. Did I unhook the VSS wire when I pulled my unit out or does it read 0 since it thinks the parking brake is installed? If everything is working ok so far should I just leave it until I start getting grief? Thanks

Got it, Thank you

Switch or Cluster Blue plug pin 18? I'm sorry I don't know what that means, is that a blue plug into the fuse box, I don't think so as none of them are blue. I followed the ground, and and it's meets 3 other wires that are all taped up, can you give me a little direction as to where the light green/red wire is. Thanks

Just about done the install on the Z2, but having problems locating the parking brake wire. I did read some where that its the lt green/red or just lt green, can anyone verify for me please. Thanks Scott