paul9895

I am not sure how you would do it without the remote, I'll check with JohnP. and see if he knows. Here is a list of the pages: 1. Version check 2. Error log 3. Format FLASH drive 4. Erase APL-file in FLASH 5. Clear backup memory 6. GPS backup data clear 7. GYRO SENSOR INFO data clear 8. Port status information Page 2 1.Change to display error [Message] 2. Start within debug shell[Disc & Card] 3. Program loading 4. GPS assessment[On] 5. File maintenance 6. Program forced write Page 3 1. SRAM / SDRAM test 3. RGB test 2. SENSOR test 4. MS5 check 5. Regio

That would be good wouldn't it. My touch screen was non funtional so I had to use the remote controller 1. RESET and EJECT buttons simultaneously. 2. Release RESET button only. 3. When “password entry screen†is displayed, release EJECT button. 4. Enter the password: 8 1 8 3 7 2 0 8 5. When the password has been entered, press ENTER key on the remote. 6. After about 3 seconds the menu screen will appear. From there I could Recalibrate my screen...Phew!! Thanks to John P. for the help on the code!!

Never mind I figured out how to get in to the service menu.

Does anyone know how to get into the d3's service menu? (If there is a menu of course) The reset/hold eject sequence works but after that I'm stuck.