GUMP666 Posted August 5, 2006 Report Share Posted August 5, 2006 the remote wire on my n3 stays hot(12 volts) any time that the ignition is on. i can take the face plate off and the wire still is hot. i can turn the unit off and the wire still has 12 volts. what is going on here?? Quote Link to post Share on other sites
GUMP666 Posted August 10, 2006 Author Report Share Posted August 10, 2006 come on, can't anybody answer this question? Quote Link to post Share on other sites
cntrylvr79 Posted August 10, 2006 Report Share Posted August 10, 2006 You sure it's not shorting against anything else? I've seen that happen when there's a short between the yellow wire and it, or if when it's hooked to an amp a strand of wire from the battery lead is touching the remote lead of the amp. Quote Link to post Share on other sites
jimmy303 Posted August 11, 2006 Report Share Posted August 11, 2006 Yeah, check that the wire isn't shorted at the amp. Also, do you by any chance have your switched lead hooked up to a constant? Quote Link to post Share on other sites
GUMP666 Posted August 12, 2006 Author Report Share Posted August 12, 2006 i have unpluged the amp's and it is still hot, and i have checked to see if the acc. and the battery wires are crossed. and it is still the same. besides that, if those 2 wires were switched i would loose all my presets eerytime i turned off the truck. Quote Link to post Share on other sites
skirodeo7 Posted September 12, 2006 Report Share Posted September 12, 2006 i have the same problem. the blue lights on the fron of my unit never turn off either. does yours do that too? i think it was wired in wrong somehow. i can't think of what would have been connected wrong, but i really need to try and fix it Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.