JCSawyer Posted April 20, 2008 Report Share Posted April 20, 2008 Good evening all, I have searched this forum over to avoid asking a question that was already available. I have a Z2 that has no open spots for moving a pin so I can ground and do the bi pass. My unit even has the newest software straight from pioneer. Manufacture date is Nov 07 and I have already grounded the e-brake wire. The pin position that should normally be grounded with Super Hippocrite's directions is actually my front left speaker positive wire. Just to be safe I have looked a dozen times and there are no pin positions available to ground. Any ideas on which wire I may be able to ground? TIA Jim Quote Link to post Share on other sites
inferno999 Posted April 20, 2008 Report Share Posted April 20, 2008 That's not AV connector 2 - you're looking at the power/speaker connector. Quote Link to post Share on other sites
rebel97 Posted April 20, 2008 Report Share Posted April 20, 2008 You need Harness #2......Not the power harness. Quote Link to post Share on other sites
big-fokker Posted April 20, 2008 Report Share Posted April 20, 2008 I ran into this as well when I first installed mine. My unit shipped with two RCA harnesses, but the second one was the incorrect one. In fact, I still don't know what that thing is for. I bought the correct one on e-bay and then I thought to contact the seller I got the Z1 from and they sent me the correct one as well...so I ended up with two #2 harnesses. If you still need it, I have it. Send me a PM. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.