chlngr1970 Posted June 4, 2009 Report Share Posted June 4, 2009 I purchased a GEX P10XMT for my AVIC Z2 and am having trouble getting it to work. I connected both the IP Bus cable, and the XM Data cable, with the Powers and ground. The XM button does not come up, and when I check the status, it says XM is not connected. This is the second one I have tried. When I conected it to my AVIC D2, it worked. I need to check the first one with my D2, to see if I have the same issue. Any ideas? j Quote Link to post Share on other sites
03Aviator Posted June 11, 2009 Report Share Posted June 11, 2009 Be sure and double check the instructions. You don't use all the power cables if you use the IP Bus cable. Other than that, the only thing I can figure is a poor connection. Quote Link to post Share on other sites
bridge4d Posted June 20, 2009 Report Share Posted June 20, 2009 Make sure the ACC+ wire is not hooked up on the GEX-P10XMT. This wire is not used if you use the IP cable. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.