ovalball Posted September 1, 2009 Report Share Posted September 1, 2009 I have added a couple of mods to my F900BT so I am ok with testmode etc.I tried to install the official 2.009 pioneer upgrade but just get stuck in the start up loop.I also tried installing the 3.00 upgrade from here with the same results.Can anyone tell me what I am doing wrong? Quote Link to post Share on other sites
Segler1963 Posted September 1, 2009 Report Share Posted September 1, 2009 You propably tried to install 2.09 over your mods, depending on the mods this can brick your unit. Use this: viewtopic.php?f=33&t=25424&p=173323&hilit=dismount#p173323 step by step to get your system to a clean 2.xxxx. I hope you have your flashdisk backup (without the mods) on hand. Once you have done this you should be able to install 3.0 See you Jörg Quote Link to post Share on other sites
ovalball Posted September 1, 2009 Author Report Share Posted September 1, 2009 Thank you.Unfortunately i only backed up my flash drive AFTER i had installed CMH's mod unziptosdcard.I will try to DL a clean V2 as you suggest.Thank you again. Quote Link to post Share on other sites
Segler1963 Posted September 1, 2009 Report Share Posted September 1, 2009 Use the CE Image from your backup, there are a lot of wrong images floating around, maybe you can just use your Flashdisk and replace only the modded files with downloaded ones. then you should be good Good Luck Jörg Quote Link to post Share on other sites
ovalball Posted September 1, 2009 Author Report Share Posted September 1, 2009 Thanks Jorg but no luck.Have posted another cry for help hoping someone has had the same problem Quote Link to post Share on other sites
Jojeli Posted September 2, 2009 Report Share Posted September 2, 2009 This problem is caused usually by nav part, so problem is most likely in APL2\IGO-folder. If you have clean installation files, try to delete this folder from your flash disk and then copy clean one to flash disk. If you just copy new folder it doesn't overwrite existing folders completely; if there's files in existing folder which aren't in folder being copied, those "extra" files are left to flash disk, which may cause problems. I found this by myself when I copied corrupted speedcam.txt-file to my flash disk; my avic stuck on "system startup in progress"-message, even when I copied original backup if APL\IGO-folder, it didnt fix the problem as this corrupted file was still present. Also try to delete files in user\userdata\igo-folder. Quote Link to post Share on other sites
yeek Posted September 2, 2009 Report Share Posted September 2, 2009 First make sure you have the original license file (the one comes with your device) in the license folder. To find out why it stucks, just run the ezrider.exe within TestMode. Most time, "System start up in progress" problem can be fixed very easily. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.