Itchy Posted December 4, 2006 Report Share Posted December 4, 2006 I've been going nuts over this. I cannot find the VSS for a 2004 Ford Explorer Sport Trac. It's not at the radio harness (basic stock radio). There's no gray/blk wire at pin position 68 or 58 at the PCM. There's no wire there at all. I checked with a digital mulitmeter at each pinout of the gauge cluster. No luck. I'm so desperate that I'll paypal the 1st recipient who can tell me the exact wire color and location that I can get to. I'm looking for the exact wire, not just responses such as"check the abs module, or check the cruise module." I don't have the know how to find these modules. Success will get you $5 paypaled to your email address... no joke. I'm installing a D1. Thanks, -Mark Quote Link to post Share on other sites
cntrylvr79 Posted December 5, 2006 Report Share Posted December 5, 2006 2004 Ford Exploder Sport Trac Speed Sense GRAY/BLACK (AC) IN HARNESS ON PASSENGER SIDE OF ENGINE COMPARTMENT or Speed Sense gray/black PCM, pin 68 Notes: The PCM is on the passenger side firewall, under the hood. That's all I have listed. merry xmas anyway. Quote Link to post Share on other sites
Itchy Posted December 5, 2006 Author Report Share Posted December 5, 2006 Thanks. I haven't heard of the harness in the engine compartment. I'll see if I can locate it. Everything's pretty tight underneath the hood in the car. I even ordered Ford repair DVDs with the wiring schematics for the entire vehicle. Quote Link to post Share on other sites
PaisanNYC Posted December 6, 2006 Report Share Posted December 6, 2006 Where's his 5 bucks? I think he gave detailed enough info! Quote Link to post Share on other sites
Itchy Posted December 6, 2006 Author Report Share Posted December 6, 2006 It's still in my pocket. There's no wire on pin 68 of my PCM. And the "harness on passenger side engine compartment" is not the detail I was looking for, but it helps. Maybe I can offer him a $1? Quote Link to post Share on other sites
PaisanNYC Posted December 6, 2006 Report Share Posted December 6, 2006 I just looked it up in what I have, and it says pin 58 OR 68... Here, and good luck! > SEARCH RESULTS 2004 FORD EXPLORER- EXPEDITION VSS Wire: LOCATION 12- POSITION 58 OR 68 OF 104 PIN CONNECTOR VSS Wire Color: GRAY/BLACK Quote Link to post Share on other sites
Itchy Posted December 6, 2006 Author Report Share Posted December 6, 2006 Thanks, but pin 58 & 68 are vacant on my PCM. I'm compiled some possible points from a sport trac forum and will test them out on Thursday when I have access to the vehicle. I also should get my 2004 Ford factory repair DVD by then to verify the diagrams. Here's my best bet thus far: http://www.mysporttrac.com/shared/msgbo ... ysporttrac Quote Link to post Share on other sites
Itchy Posted December 8, 2006 Author Report Share Posted December 8, 2006 I received my Ford Service Manual DVD and spent some time looking up some diagrams. I picked up the VSS connection at the windshield wiper motor connector Gray/Black wire. It was very easy to get to, easier than the PCM/ECM. This Ford has speed sensing interval wipers. Avic D1 picked up the pulse. Nobody won the prize. $5 stays in my pocket Quote Link to post Share on other sites
tillithz Posted December 8, 2006 Report Share Posted December 8, 2006 i seriously doubt any suggestion was even done for the $5 but good ya figured it out. Quote Link to post Share on other sites
ntrprize Posted December 28, 2006 Report Share Posted December 28, 2006 Heres a little more info. I have a 2005 Explorer. It did have the grey/black wire behind the radio. It was NOT in the main radio harness. There is a secondary harness in the dash. It looks like a 16 pin square connector, but there were only 2 wires in it. One of them was the VSS wire. The secondary connector is used for premium audio systems. Mine was not a premium system, so this connector was tucked away where it was hard to find. It does meet up with the wires from the primary connecctor, so if you follow it back far enough you should find the other connector. Also, I do NOT know if all explorers had this connector in them, but it is a place to check. I know you have yours hooked up, but I added this information for users searching in the future. Quote Link to post Share on other sites
aeye8712 Posted April 15, 2007 Report Share Posted April 15, 2007 Can you provide a bit more detail as to the location of the wiper motor in the 05 sport trac for those of us without the wiring diagrams? =) I think I've found it inside the engine compartment on the driver side, attached to the top of the firewall. I've found a gray black wire attaching to that harness. Am I in the right spot? I also noticed from your article on mysporttrac that you were debating running the line back through the firewall. If you ever got that worked out could you advise as to where / how to come back through the firewall? Thanks! Andrew Quote Link to post Share on other sites
Itchy Posted April 15, 2007 Author Report Share Posted April 15, 2007 Sounds like you found the wire. As for the firewall, I used an existing grommet a couple feet below the wiper motor. Puncture a hole with a screw driver through the rubber grommet and run the wire through. Quote Link to post Share on other sites
aeye8712 Posted April 15, 2007 Report Share Posted April 15, 2007 Thanks for the quick reply on a sat night. =) Where did the grommet you used come through in the passenger compartment? I've found what I think is the spot you are talking about with a single thick black line coming through just to the left of the brake pedal on the drivers side. Is this the spot you came through? Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.