dlk Posted August 11, 2010 Report Share Posted August 11, 2010 Just completed bypass & everything works fine, but there's always this warning on bootup about the PB wire not being connected properly. This warning appears before putting the car in gear. Not sure how it determines this fault because I could actually have the PB set at this point. PB status under SetUp/Nav is "ON". Quote Link to post Share on other sites
dawgbone Posted August 11, 2010 Report Share Posted August 11, 2010 I believe there is an update that resolves this issue... http://www.pioneerelectronics.com/PUSA/ ... 10BT?tab=F Hope that solves your issue.... Quote Link to post Share on other sites
dlk Posted August 11, 2010 Author Report Share Posted August 11, 2010 Thanks dawgbone. I've seen that, but it says for Z110 only. I hope'd they had incorporated that in this new version but doesn't look like it. Quote Link to post Share on other sites
VBLUE42 Posted August 11, 2010 Report Share Posted August 11, 2010 It is likely you have an improper connection with your bypass. Check your connections. Quote Link to post Share on other sites
dlk Posted August 12, 2010 Author Report Share Posted August 12, 2010 Sensor status says it's "ON". Quote Link to post Share on other sites
dawgbone Posted August 12, 2010 Report Share Posted August 12, 2010 I didn't pay attention to the thread title... VBlue is right... Otherwise.... run that update for grins.... Quote Link to post Share on other sites
dlk Posted August 15, 2010 Author Report Share Posted August 15, 2010 VBlue42 - If the sensor status says "ON" how can it be bad? If it weren't connected I don't believe it would detect anything unless I'm missing something about what the the sensor is looking for. Quote Link to post Share on other sites
dawgbone Posted August 15, 2010 Report Share Posted August 15, 2010 VBlue42 - If the sensor status says "ON" how can it be bad? If it weren't connected I don't believe it would detect anything unless I'm missing something about what the the sensor is looking for. If your P-brake is grounded it will read on.... It the other(mute) wire that you moved over that isn't getting grounded... Check it's connection.... You may have not pushed the pin in completely..... Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.