coldranger Posted May 3, 2007 Report Share Posted May 3, 2007 I'm trying to figure out if tapped the right reverse wire or not. In the "connection status" display, the back signal strength says "high." However, it does not change when I move the gearshift into reverse. Is this the correct setup? Quote Link to post Share on other sites
MisFit Posted May 3, 2007 Report Share Posted May 3, 2007 if the camera comes on when you shift to reverse then you got it Quote Link to post Share on other sites
cntrylvr79 Posted May 3, 2007 Report Share Posted May 3, 2007 No, it'll say high when you're in reverse and low when you're not. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.