csanchez70 Posted August 29, 2007 Report Share Posted August 29, 2007 My screen has been off for a while, when I push on the left side of the screen it clicks the option about an inch to the right of where I pushed, very troublesome for using the Navigation. I tried the recalibration suggestions and here is where I'm having problems. 1. In the 1st Calibration menu here are the numbers I get before and after calibration, I don't get the error message but the problems isn't fixed. min x before (42,90) after (42,63) max x before (245,180) after (245, 237) min y before (50,90) after (50,51) max y before (236,180) after (235,235) Do these numbers look ok? 2. In the 2nd menu where you click on the cross as it moves around the screen I have to start pushing left of the cross for it to register, especially as the cross moves to the left side of the screen. I then save settings but nothing has improved. Any ideas, thoughts, suggestions would be much appreciated. Quote Link to post Share on other sites
Rick1962 Posted September 12, 2007 Report Share Posted September 12, 2007 I had the same problem.... Don't reset when you are done with step 1-4. Turn key off wait 10 sec turn key on wait 10 sec turn key off wait 10 sec The next time you turn on the key it should be fine. Need to recalibrate if you perform a reset. Must be a internal battery or something. Quote Link to post Share on other sites
dodge11 Posted December 12, 2007 Report Share Posted December 12, 2007 once you make the changes... how do you save them? Quote Link to post Share on other sites
dodge11 Posted December 12, 2007 Report Share Posted December 12, 2007 I can't get past the 1st screen calibration test... It says, trace the white line... I do, then hit "back"and it says it is outside of parameters...any ideas? Quote Link to post Share on other sites
rford41 Posted March 27, 2009 Report Share Posted March 27, 2009 I ran into the same problems calibrating on the left side. I slightly lifted the plastic along the left edge and used a thin stylus. (consider that there is more screen continues under the edgeing). It worked and I was able to complete the calibration process. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.