necro Posted September 13, 2007 Report Share Posted September 13, 2007 Ok. I installed the D3 in my 2003 Mustang flawlessly. Today, I installed the D3 into my 2007 Tacoma. Everything went smoothly until it turned on. Now it's asking me if I want to start the Nav or go into Demo mode every time I turn it on. I have an idea what could be wrong but wanna check here before I go poking around. Ideas??? Quote Link to post Share on other sites
HiFiSi Posted September 13, 2007 Report Share Posted September 13, 2007 Did you perhaps hook the constant power wire to the switched power source (ignition)? It sounds to me like it's resetting the unit every time you turn off the ignition. Quote Link to post Share on other sites
necro Posted September 13, 2007 Author Report Share Posted September 13, 2007 Problem solved. Apparently, it's a question it asks when the power is disconnected and then reconnected the first time. Because I wasn't moving, it kept asking to "Start Nav". After I drove to work this morning, I checked it again and it's working fine. Now if I can just get my rear camera mounted... Quote Link to post Share on other sites
installthis06 Posted September 13, 2007 Report Share Posted September 13, 2007 Now if I can just get my rear camera mounted... duct tape! Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.