TLud

Thanks, me too. I learned my lesson about makings sure all the wires are tucked away properly before screwing anything down.

Well, I figured it out. I tested all the fuses with the meter, but none of them gave me a 0. I have wiring and current diagrams for my truck, and there are four fuses between the Z1 and the battery: one in the engine bay, one in the accessory panel, and two aftermarket ones on the wire itself. Looking at the diagram, I narrowed out the accessory panel fuse (if it was bad, a couple of other things would have gone out, but only the Z1 was dead). I pulled the aftermarket fuses and they looked fine. Sure enough it was the fuse in the engine bay. Replaced it, and now the Z1 is up and running

I've had my AVIC-Z1 working perfectly for 2 months now. I had a rattle in my dash, so I opened it up to tighten things down. Putting my navigation system back in, the battery wire got caught between the head unit brackets and the frame. When I tightened it down, it cut the wire without me knowing about it. I realized something was wrong when I turned the truck on and the navi system remained blank. I opened it back up, found the broken battery wire (which I patched back together), but my navi system still won't come on. My first thought was that I had blown a fuse, but I checked the fuses

[quote name="honda4x4nut"]Tlud where did you get the wiring diagram for the Tacoma My girlfriend has one and I needed the vss(which i have now) but the rest of the wiring would be good to have too. Thanks[/quote] Wiring diagrams plus anything else you could possibly want to know about the Tacoma: [url=http://www.markass.com/toyotanation/]http://www.markass.com/toyotanation/[/url]

Thanks, man. From looking at a wiring diagram, I was pretty sure it was a green wire going into the number 2 pin. This gives me enough confirmation to proceed.

Can anyone tell me which color wire (pin no.) and harness the ILL wire going to the headunit is? TIA.

Ummm, weren't you supposed to use the 150 ohm resistor (brown-green-brown)?

Thanks! I found a wiring diagram for my truck, but wanted to make sure I was pulling the right wires. This is my first time installing anything on this scale, and I don't want to make an expensive mistake.

Can anyone tell me where to find the VSS wire on an '06 Toyota Tacoma? Thanks.