siberfish

Remove any disk's from the headunit. Hold reset and eject together, then release the reset button but continue to hold eject. The screen will go in and the come back out. The screen will now say to press the reset button - DONT FOLLOW THIS PROMPT. Then with joystick, (knob on the rigt side) follow this, by moving the joystick in the directions below: Up, Right, Up, Right, Down, Right, Down, Righ and then finally press the joystick inwards, in the center. Now, the password screen will come on for a few seconds followed by the test mode. When you are on the first page in th

In performing a test mode screen recalibration, after tracing the exterior of the screen in step 1, when I then go to the recalibration screen, it will not let me click on the + symbols. The calibration screen acts similar to the test screen, where I have to press the screen where it "thinks" the + is before it will allow me to move on to the next +. Do I have a setting worg or something? Please advise, and thank you in advance.