jerzboi83

Damn you're good at this. Thanks a lot man.

Hey all, I'm a big Opie and Anthony fan and I was wondering if anyone could possibly put together some nice O&A/XM related backgrounds. I would post some clips to use but I don't know where to find any good ones. And I'm horrible with photoshop. Thanks in advance.

Well I'll be damned it was the ground. I've checked it with the meter and it was giving me a good reading but the connection was loose. I got so tied up in thinking it was something else I didnt bother to check the ground. Good thing you said something otherwise I'd still be losing my mind over it. Thanks a lot for bringing that to my attention.

The unit came back from Pioneer and it is still not working. I'm waiting for a call back from tech support. To update, I was driving on a highway at about 75 mph and my XM cut out for no reason so far as I can tell. The XM button on the source menu had become greyed out. I pulled over to do a quick check on the power supply and to make sure all the cables were plugged in and the unit still did not work. When I got back home I tested the power cable, the IP-BUS cable, the 30-pin yellow cable, the XM antenna, and the data cable with a meter and all were good. I've pressed both reset but

Next time you decide to post ads on a forum you should double-check to make sure you've at least used the correct language. Either that or clean the spilled coffee out of your keyboard before typing them out.

I contacted Pioneer about my problem and they seem to think its the flex cable. I'm mailing it out tomorrow on the 16th. I'll post an update when I get it back.

Is this for an XM connected to AV input? Because my XM is connected to the IPBUS.

Yes I hit the reset button on both the xm tuner and the dash unit and neither fixed the problem. I even went so far as to reflash it and it still doesn't work.

This problem first occured during a long 3 hour trip. I was doing about 75 on the interstate and the XM just cut out for no reason. The XM button became greyed out and I couldnt select it again from the input menu. I first checked the fuse and the ground on the XM and both were good. I then tested the IPBUS cable and the data cable with an ohm meter and both were good. I figured it was the XM unit that was defective so I picked up another unit and plugged it in with the new wires and antenna. I got the same problem. Does this mean the brain is bad? Has anyone else had this problem and