destln3d

Hey dude... I had the same problem as you and now I got the update to work. The first time around, I thought I followed the directions but realized that I misunderstood them a little bit. In step 11, I deleted everything inside the My Flash Disk Drive. Then I went to the SD card... Opened the My Flash Disk folder... Selected All from Edit, then copied the contents. I went back to the My Flash Disk Drive and pasted the contents there. My mistake on the first attempt was that I copied the actual folder and just pasted the folder into the My Flash Disk Drive. I hope you try this an

Did you backup your unit first? If you did, all you have to do is copy your entire myflashdiskback to your unit. If you didn't, you made a big mistake. There may be someone on this forum that has a full backup somewhere. You will have to look and search. here you go!! ftp://www.turboss.com No I didnt back it up..didnt know how to. now how do i use it...do I put all the rar files un-zip on the flask disk?? or are they loaded up individual??...I appreicate you guys trying to help me out on this..Im a noob when it comes to the stuff.. I thought by following the instruction

i tried everything...followed the instructions down to the T many times...this sucks cause now I have to take it in to get fixed which will be over a 100.00...i guess i shouldnt have been so cheap and bought the update even though it should be for free...does anyone know how to load the old firmware that you get from the pioneer site without getting errors???

okay I see post saying that you might have the old testmode files and you need to replace it with the new ones...where do you get the new ones??? and also testmode...thats the window base OP system thats boots up correct??

well i tried to load the old firmwire from the pioneer site and all I get are errors...so Im going to reload the 3.0 on it once again and hopefully I dont get the same issue for the 4th time..if I do Ill try what you said and see if that works...did it work for you???

at the end copy what files...Im trying it your way cause it seems the other way isnt working for me The flash dump from the X series AVIC that you torrented in the beginning of the instructions. Unzip the file and browse the contents. Inside you'll find a folder called 'My Flash Disk'. Put that folder on the SD card, boot into testmode, and copy everything in it onto the AVIC's 'My Flash Disk' folder. I just did all of that...Im still having the same issue where it goes to a black screen after a min of it being on the splash screen... I do not know what the deal is =(

at the end copy what files...Im trying it your way cause it seems the other way isnt working for me

Okay I dont know what I'm doing wrong...but I followed the instuctions exact. I re-did everything all over again 3 times and I'm still getting the same issue. AT the very last step I hold eject and reset for 5 secs, It reboots and shows the splash screen for like a min and then my screen goes BLACK and all the LED lights turns off the system but you can still hear it running. Can someone please help me???

I have the AVIC 700 and I followed all the steps on the outline of the installing guide. When I reach the last step of holding the reset and eject for 5 secs, it reboots and shows me the background screen for a min and then goes black, the whole system turns off