Point4Dave

Worked great on my 920.

I just have to redo it because I done goofed and installed Europe maps.

*bump*

Is it a setting or should I pickup a new reverse camera ?

Look for an option about Camera Polarity

That has nothing to do with a reversed image. All that does is reverse the function. ie: set it to ground it will always be on except when you go in reverse. set to battery will turn on when in reverse.

Had the battery out for a day while doing a CMC swap.

Now with the car powered back up when I go into reverse the camera comes on like it should but the image is reversed and the guides no longer show. I can't find a setting for it anywhere, am I missing something here or is the camera on its last legs?

It's a problem with the X920BT. Pioneer won't acknowledge it. It's not a mic replacement or placement problem. I've been through this so many times. Basically if you have the 920 don't expect to use you bluetooth while driving.

I drilled a hole in my overhead lights/switches and mounted the mix flush in there. Very same location where it's been on my d3 and my 920.

I have a 920 and the mic flat out sucks, I got to the point that I don't use it, It sounds great if I am stopped, But while I am driving it sounds bad.

I have the exact same issue. Fine at stop, start moving and it's crap. My avic-d3 sounded perfect, changed to the 920 and this happens. I wonder if changing the mix altogether to a higher quality one would make a difference.

Anybody ?

The bluetooth firmware is 3.11 on my 920. Where do I get the latest update from ?

I been looking around and can't find a definite.

Does anybody have the download file? I'm ready to do this.

Same issue. Installer didn't hook it up. Time to yank out the volt meter.

*resolved*

No guarantees, but I've read of this problem on the Avic411 forums and have heard that often all you have to do is move the mic. Don't know why, but for many it seems to work. I changed my mic to a better one (long time ago). Also, are you running the latest Bluetooth software update? Search the forum and you should find where to get it (Pioneer has it free) and how to install. You didn't state which deck you are now using. But hope this helps. Your deck should also tell you what software you are running currently. Good luck.

Thanks for the info. I'll take a look at it tomorrow and read up on it. It's a x920bt.

What kind of microphone are you using ?

Got everything installed. Setup my iPhone and test called my wife.

She can hear herself echo'ing back even though the desk has Echo Cancel set to On, I tried it on Off, same thing.

On my old D3 the bluetooth had no echo at all. What gives ?

*edit*

No, it's stored on internal flash memory.

Thanks... Any tips/tricks I should be doing with this unit other than the parking bypass ?

I'm having the unit put in tomorrow finally (had to wait on a new original wire harness from Honda).... On my old AVIC D3 I had a DVD disk with

the map software. With this unit no DVD disk nor SD Disk was included, am I missing something ?

Yes, it will.

Thanks for the reply.

Just picked up an AVIC X920BT unit and putting it in next week once my ipod cable arrives for it.

Does anybody know if my existing XM Tuner (GEX-P10XMT) will fit this unit ?

Thanks

I think the iPod cable is pooched. The dealer installed it with the deck so it's probably a knock-off lol.

What happens is if I plug in my iphone or an itouch it says 'ready' on the deck but nothing plays.

The message changed on my phone from saying 'airplane mode switch' to just 'device not supported for charging'.

If I plug the iphone in then turn on the car for power, the deck remains black and will not power up at all.

My phone also goes wonky and I have to reset it for it to work properly again after plugging it in.