momo422001

ya thats where i installed the new maps, but nothing worked, instead my 700 wont even start up. i checked new files were .fbl anyways i had to reload the 3.0 firmware and then it again works fine now, with 200810 ta maps..

hi i have avic f700bt, which i recently updated to 3.0 from 2.06. i found new 2010ta maps for northamerica and downloaded them, what i did was i deleted the maps and poi in igo folder of the myflash disc on sd card and replaced them with new one and after that i went in test mode and copied the new maps to the unit, but after booting the maps still show 2008-10 only... i did research in all the topics even tried putting fx3.1 after which the unit didnt even start so i reverted back to 3.0, which works fine but still the old maps, any help will be greatly appreciated.. thanks

so i think either the maps or the file is corrupt. just loaded 3.0 works fine..

i think maybe the maps are corrupt. so im trying right now to put 3.0 back with 2008 ta maps , hope it works..

didnt work on avic f700. crashes and screen goes blank after the logo. i was using 3.0, can i go back to 3.0, if yes then do i have to do the same steps as given in tutorial for 3.0 installation, right now my 700 is unusable.