AudiJarhead

I have an F700BT, and am trying to install it into an audi a4 as this gentleman on the forum did with a scosche dash kit. http://avic411.com/index.php?/topic/19377-2006-audi-a4-wiring-f700bt-updated/ I am getting a gap around the exterior of the kit caused by the indentation that goes around the perimeter of the F700bt. I think this gap also exists in other F series and the X series. Question for you lads and (lasses). Did the AVIC F700BT come with a trim ring to close the gap? I got mine from my little brother used when he ripped it out of his old car and sold it. If it did come wi

I had the same problem with my AVIC F700BT when I tried to upload 3.0... I followed the directions, on this forum, then did it again and the update took. It took twice for me to upload the files via test mode for the update to take, then voila no black screen. You should refer to the dude who uploaded the files onto megaupload, his directions were money. And from there I updated to 3.2 directly (No you do not need to update to 3.1 to get 3.2 despite what people tell you, mine installed just fine from hacked 3.0, without fooling with 3.1.)