duderstadt

I am going to pull the unit again later today. I do not remember if this wire was hooked up. If not, then I put it in the pin slot where the mute wire goes and ground it, right? I will disconnect the "switch" he put in also. I do plan on checking all of the grounds also. I have a feeling this could have been the original problem. Thanks

We did not install any amps. He used a harness to wire the unit to the existing factory amps and speaker wires. Any problems if I move the wire?

Hey, My installer could not get the bypass to work with my 05 Expedition so he put in the "switch" for the bypass. It works randomly. Not very happy. I pulled my unit and found he pulled the mute wire from the connector and cut the pin off. Where can I get another wire harness so I can do this bypass the right way myself. Thanks

I put in a D3 in my 2005 Expedition. The bypass did not work. I followed the instructions. Going to check the pin to make sure it did not get damaged. Any other ideas ? Also, is it safe to hook the illumination up to the Expedition ? I heard you could short out wiring systems? Urban myth ? Thanks everyone