robiaman
Members-
Content Count
11 -
Joined
-
Last visited
About robiaman
-
Rank
-
AVIC Z130 - upgraded to Z140 No roads displayed
robiaman replied to cmcneal's topic in Problems/Troubleshooting
No road their are fewer roads available on the new map set. Be nice to know how to downgrade -
Yes had the latest firmware and all function work fine before the update .i did the reset found in the units sofware setting but no better results there is voice but the voice says due to limited data guidance cannot be provide in this area. But like i said the route is marked properly on the map and if i go to rout overview and profile the directions are correct... It like there is missing voice instructions
-
Thanks Ron for the reply...."do to limited data guidance can not be provided in your area" is still proving to be a problem, ive tried diconecting the battery over night but it did not reset the avic z130bt like a wrote in a previous post the map shows up with the route highlited but there are no diretions....no arrows with voice. Thanks for your support.
-
I have loaded the new maps 2012 as per fist post, everything loaded fine however once I took it out for a test run I noticed that my deck , z130bt, would map the road correctly but not give voice direction. instead it told me insufficient data for this area... I read other having the same issue but no answer to the problem. If you could help I would be grateful and to make clear I have read all post thus far. If I missed a solution your direction would be great. thanks all and great site. by the way I used the auto method for the update as per this thread.
-
AVIC Z130 - upgraded to Z140 No roads displayed
robiaman replied to cmcneal's topic in Problems/Troubleshooting
Any solution out there same problem here no road display!!!!haaaaaaa -
I have loaded the new maps 2012 as per fist post, everything loaded fine however once I took it out for a test run I noticed that my deck , z130bt, would map the road correctly but not give voice direction. instead it told me insufficient data for this area... I read other having the same issue but no answer to the problem. If you could help I would be grateful and to make clear I have read all post thus far. If I missed a solution your direction would be great. thanks all and great site. by the way I used the auto method for the update as per this thread.