SVTandy Posted February 17, 2008 Report Share Posted February 17, 2008 Hello all, installed the two units myself. the XM unit was a refurb. connected everything correctly: D3 IP-bus blue connector to black IP-bus out on XM unit data cable is connected to their respective ports on each unit. power only(yellow) and the ground are connected. left the red ACC disconnected. and the antenna is also connected of coarse. I get the XM signal great. but I cannot get the xm to activate( all the channels), now the thing I noticed is that it is in "UPDATING" status since I plugged it in. how long should it take to update the latest encyption code? minutes hours? and would that do anything for my activation of my account? Quote Link to post Share on other sites
whtcrxghst Posted February 18, 2008 Report Share Posted February 18, 2008 Try pulling the car out into the open, leaving the XM turned on, and refresh the signal. You can do that either by calling XM or going to xmradio.com/refresh. I have seen it refresh in anywhere from a few seconds to like fifteen minutes. If that doesn't work, you have an issue with the box, or with the XM activation Quote Link to post Share on other sites
SVTandy Posted February 18, 2008 Author Report Share Posted February 18, 2008 well, all was taken care of. the unit was a demo unit and was still active under said account. once turned off under the old account and reprogrammed under mine it worked fine. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.