jesusq Posted February 22, 2008 Report Share Posted February 22, 2008 I have the n2 and just received it back from Pioneer after the Flex cable gave up on me. When I had it installed they put a bypass switch so that I can use the navigation or watch movies while driving. I also upgrade the software from the 50mt to the 70mt right before sending it to Pioneer. Once I received it, I'm not sure if they did a firmware upgrade on the unit, but I am getting an "Improperly configuration of the brake cable" error. when I check the status of the cable, it shows Brake ON, but if I drive, it changes from Brake ON to Brake OFF and I cannot use the navigation unless I come to a complete stop. I haven't tested a movie since I normally don't watch movies while driving. Is there something new that I need to do so that i can use the navigation while I'm driving? I also tried to use the 50MT cd and it gave me an error as well telling me that I was using the wrong CD. Please help, I use the navitation very often and spontanious, so punching address while driving is very useful for me. Thanks, Quote Link to post Share on other sites
whtcrxghst Posted February 22, 2008 Report Share Posted February 22, 2008 You need to do some soldering like you did the first time you bypassed it Quote Link to post Share on other sites
jesusq Posted February 22, 2008 Author Report Share Posted February 22, 2008 I had the radio installed by someone who I am no longer in contact of. I've also been reading this forum for what to solder and pictures and I cannot find the post. Does anyone know where that post is? Or is there any pictures of how to do this? Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.