supernet Posted February 29, 2008 Report Share Posted February 29, 2008 When turning on car, it says " improper break lead" is that because of my by pass? Quote Link to post Share on other sites
kruff10 Posted February 29, 2008 Report Share Posted February 29, 2008 i had that same issue, until i did the the bypass the correct way. Quote Link to post Share on other sites
supernet Posted February 29, 2008 Author Report Share Posted February 29, 2008 i had that same issue, until i did the the bypass the correct way. What was wrong with urs??? Quote Link to post Share on other sites
wpageabc Posted March 1, 2008 Report Share Posted March 1, 2008 Check your work! Quote Link to post Share on other sites
firebirdude Posted March 3, 2008 Report Share Posted March 3, 2008 I've only seen this one time. AND IT WAS YESTERDAY on an N2! When we bench tested it before installing, it came up with that alert. No biggie I think. (Obviously because the wire isn't connected to anything) But then the alert continued after installation. I'm positive I hooked up the parking brake wire to the correct wire on the parking brake. Video even displays fine with parking brake engaged...... so I'm stumped. PS. I'm not attempting any type of bypass. My job is more important than some random shmuck's "wants". PPS. And $100 cash doesn't even come close to changing my mind.....lol Quote Link to post Share on other sites
HiFiSi Posted March 3, 2008 Report Share Posted March 3, 2008 Maybe the pin where the parking brake wire goes into the D3's harness came loose? I can't find anything about that error message in the manual... But maybe I just didn't read carefully enough. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.