ccameselle Posted May 6, 2008 Report Share Posted May 6, 2008 ok I have to report that it was the dash and the way that entering the contacts in the 8125 phone book. If you enter the number using the keypad it works fine. Do the following. Press the Green button like if you were to make a call. You will get the number keypad on the screen. Enter the number that you wanna save IE: 3051234567 just like that. Hit menu on the bottom right Hit save to contacts. (notice that the number does not have spaces or dashes on it) Give the contac a name and hit OK on the top corner and you are done with the creation of contact part. Not do the rest Upload contac to the BTB-200 and you are set. Again THANK YOU to all of you that help me during the setup and install Carlos Cameselle Quote Link to post Share on other sites
tobyzy Posted May 7, 2008 Report Share Posted May 7, 2008 I cant even get the settings button or many others to light up to allow for setting the phone. Did I miss a wire or something since they are dimmed out? Cant even set clock. Quote Link to post Share on other sites
ccameselle Posted May 7, 2008 Report Share Posted May 7, 2008 You need to either usen the emergency break if you connected that wire from the radio or you need to check your ground. I have my radio hacked so I can use the Nav while driving. You do not have to hack the radio if you do not want to, but the Brake wire (lime green) needs to be connected. Then if you do that you will need to stop the car and put on the emergency break to use those functions. If you want to know how to hack the system so you can use it while driving then take a look at this post. http://www.avic411.com/forum/viewtopic.php?t=12693 Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.