Don Nguyen Posted October 3, 2008 Report Share Posted October 3, 2008 I know this is probably a simple question/problem, but I can't seem to figure it out. I have a set of front speakers, tweeters and mids. When connecting the speaker wires to the AVIC N3 unit, I noticed that in the installation guide it only specified front speakers, and not seperate for the mids/tweeters. Is that correct, or did I wire them wrong? thanks. -Don Quote Link to post Share on other sites
garrettoomey Posted October 3, 2008 Report Share Posted October 3, 2008 Typically the mid and tweeter is connected to some type of cross-over/hi-pass. The N front speaker connectors would go to the cross-over. Quote Link to post Share on other sites
AudioKrayzy Posted October 8, 2008 Report Share Posted October 8, 2008 garrettoomey is right but in the case you bought them as sepperate componets then you would run the tweeters in parallel with the mids but you might want to add a cap on there Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.