ipxnsv Posted February 19, 2009 Author Report Share Posted February 19, 2009 That may be the best idea. It was an experiment over all for me.. But i like the the way it turned out.. plus you can buy new switch covers for like... 2 bucks! Quote Link to post Share on other sites
spta97 Posted February 19, 2009 Report Share Posted February 19, 2009 thanks for the tip, ill probably just do some gorilla glue on the back side and see how that works out. I would suggest using clear silicone. It will take longer to setup, but is removable if you want to take it out. I used silicone to mount a wood amp rack to my trunk floor and it is holding up great after years. If I want to take it out for good I just have to yank real hard Quote Link to post Share on other sites
lludacrisboy Posted February 19, 2009 Report Share Posted February 19, 2009 That may be the best idea. It was an experiment over all for me.. But i like the the way it turned out.. plus you can buy new switch covers for like... 2 bucks! true, my only question or concern i have is how did you make yours so Flush?? its perfect. did you just cut it a little small and force it in there? Quote Link to post Share on other sites
ipxnsv Posted February 19, 2009 Author Report Share Posted February 19, 2009 I cut a hole EXACTLY the same size as the USB .. then glued pieces of plastic UNDER the usb cable mouth so it would stay in place under the switch and that was glued under the switch cover.. Quote Link to post Share on other sites
lludacrisboy Posted February 19, 2009 Report Share Posted February 19, 2009 I cut a hole EXACTLY the same size as the USB ..then glued pieces of plastic UNDER the usb cable mouth so it would stay in place under the switch and that was glued under the switch cover.. Awesome, Ill be sure to do that then Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.