dkoon2007 Posted July 9, 2009 Report Share Posted July 9, 2009 Whats the best way to ground the two wires? #1 wire....disconnect from the e-bake switch and run the wire to a bolt or screw? #2 wire...Relocate a wire and then connect it to the unit's ground wire via a connector? This stuff is basic to some of you folks but I have very little experience with automotive electrics. Are there better ways? Thanks in advance Quote Link to post Share on other sites
garrettoomey Posted July 9, 2009 Report Share Posted July 9, 2009 Here is the easiest. Wire #1 and #2 just connect them both to the black ground wire on the rear of the Z. All 3 of these wires will be attached to the vehicle ground. Quote Link to post Share on other sites
dkoon2007 Posted July 9, 2009 Author Report Share Posted July 9, 2009 Oh, thank you for the reply....makes sense. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.