mrbeefy Posted October 7, 2009 Report Share Posted October 7, 2009 Just installed Z110 in my 2009 VW Jetta Sportwagen. I used the Connect2 harness to connect to the CAN bus and retain steering wheel buttons. I had read on a VW forum that it retains the functionality exactly as stock, except adding the OK button becomes change source (which it does and that's nice). The problem is that the up/down arrows on the right changed the presets with the stock HU and now they are doing tune up/down. On the VW forum someone said it is a Pioneer issue. I am doubtful. I had actually bought all of the PAC stuff to use and may end up using it if I can't resolve this otherwise (plus I might be able to use the Phone button to at least answer calls whereas right now it does nothing, same as stock)... One reason I went with Connects2 instead of PAC is it is much simpler(one translation box and harness vs three) and less expensive and smaller/easier to fit behind the Z. No programming is required or possible (good and bad)... Quote Link to post Share on other sites
aleicgrant Posted October 7, 2009 Report Share Posted October 7, 2009 this is a long shot but maybe something that can be changed with the vag com? Quote Link to post Share on other sites
mrbeefy Posted October 9, 2009 Author Report Share Posted October 9, 2009 I think I would have to use the PAC stuff to change it. The Connects2 does change track when you push and seek when you hold the up/down buttons. I had a Z1 in another vehicle and with the PAC stuff setup that way it would do what the Z110 is doing, ie tune up/down. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.