chris0055 Posted March 15, 2010 Report Share Posted March 15, 2010 Greetings!! I'm new to the thread. I just purchased an X910BT and would like to hook it up to my car. I found out that there are two types of speaker output (correct me if I am wrong) According to the pinout, pin1 to pin8 from the Power Supply cord seems like where I should hook up my speaker wires to. I also found that pin1, 3, 5, 6, 7, 9, 10 are also output ports to speakers. I am now confused that which one should I go. I understand the AV IN/out contains wires with rounded plugs (sorry for bad expression) whereas the Power Supply output are just plugs. My car is ML350 03 Mercedes. I do NOT have amp nor sub and I have speaker level output wires. Any advice? Quote Link to post Share on other sites
SeeBee63 Posted March 15, 2010 Report Share Posted March 15, 2010 Use the 1 to 8 wires on the Power Supply cable. The wires on the AV cable are unamplified and would only be used when connecting your X910 to an amplifier. Quote Link to post Share on other sites
chris0055 Posted March 15, 2010 Author Report Share Posted March 15, 2010 Use the 1 to 8 wires on the Power Supply cable. The wires on the AV cable are unamplified and would only be used when connecting your X910 to an amplifier. oh great! then I know my specific wiring now! thanks a lot!! Quote Link to post Share on other sites
1loudls Posted March 31, 2010 Report Share Posted March 31, 2010 I also found that pin1, 3, 5, 6, 7, 9, 10 are also output ports to speakers.[attachment=0]F900Pin-Outs.jpg[/attachment] it clearly says that 9 and 10 are for the parking brake and VSS. i am concerned that you dont know enough about this to try to install it yourself, proceed with caution as with a car as complexed as a Mercedes, it is very easy to cause a lot of expensive damage to systems in the cars if wired improperly, including but not limited to catching the car on fire! be safe and if your unsure about anything, ASK before attempting to "just try something" Quote Link to post Share on other sites
chris0055 Posted April 5, 2010 Author Report Share Posted April 5, 2010 Thanks for the advice, I think I got everything figured out. The unit is on and I have no problem with the unit at all. I do now trying to figure out how to backup my software data. Seems like the unit does not read my SD card and I'm not sure if I'm using the correct TestMode data. Is the newest one 2.3? Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.