wishbone Posted May 30, 2006 Report Share Posted May 30, 2006 I find that every so often my unit will go into "updating" and nothing will come through on xm. Today none of the channels work and when you first boost the unit on it just says "loading" The connection screen says that xm is connected and that the signal is "very strong". Anyone else having strange xm issues? Quote Link to post Share on other sites
logan0171 Posted May 31, 2006 Report Share Posted May 31, 2006 I have not experienced anything like that. When I first installed XM it took a few minutes to update but I have not noticed anything since. I did have a weird issue over the weekend where none of the XM channels worked except for the test channel. They seemed to tune fine just there was no audio. Other than that one time I haven't seen anything else strange. Quote Link to post Share on other sites
wishbone Posted May 31, 2006 Author Report Share Posted May 31, 2006 [quote name="logan0171"]I have not experienced anything like that. When I first installed XM it took a few minutes to update but I have not noticed anything since. I did have a weird issue over the weekend where none of the XM channels worked except for the test channel. They seemed to tune fine just there was no audio. Other than that one time I haven't seen anything else strange.[/quote] This same issue has happened to me several times where you can tune to all of them, but there's no audio. Hmmm just happened again, where the unit says it's updating so it removes all my channels. I guess I'll call xm's worthless support center. Quote Link to post Share on other sites
gtownman146 Posted August 22, 2008 Report Share Posted August 22, 2008 I have the same problem as you did orginally. When I boot-up I get nothing but "UPDATING" and it won't ever get any farther than that. I can't change the volume to change, but I have all other functionability. [/quote] Quote Link to post Share on other sites
klaborde Posted September 4, 2008 Report Share Posted September 4, 2008 I have received the same problem on my two Z2's. What I do is pull over, turn my vehicle off, and restart. (Basically Re-Boot the Z2) It works every time. What I think happens, I drive into a garage and loose signal. Then when I start up again, System boots up, XM has no signal until I pull out of the garage. The "Updating..." starts up, and then it works again... It's as if the validation from XM is lost, and it has to receive it again. Reboot works every time for me. I also upgraded my HDD to Z3, and it does the same. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.