Like everyone else on here...D3 bypass problem.

[cookdiesel]

Hi guys, Nubee bypass problem. I'm trying not to get flamed here, but due to snapping a tendon in my arm I had to have an installer take care of my Avic-D3.

 

Here is what was installed:

Avic-D3

ipod adapter (CD-i200)

Bluetooth adapter (CD-BTB200)

Sirius adapter (SIR-PNR2)

PAC Steering Wheel control (PAC SWI-PS)

 

So before I took the car in I moved the mute wire as advised in multiple post, and after the installer completed the job I had a buddy move the parking brake and we grounded it to the car by itself.

 

After that all the menus opened up and all was good. Now just like on a previous post I am having the Alert screen with the message that my parking brake wire is not properly connected and the menus are not accessable to make changes.

 

My question is this: Will the reset of the unit take care of this? Or due I have to remove the unit and start over?

 

Sorry to regurgitate questions, but since I had all the extra stuff installed. I was not sure if this would cause other issues that weren't discussed.

 

Thanks for any help.

[adhood]

Double check your grounds.

If that doesn't work perform a reset.

[dub]

The installer did not ground the mute wire after you re-located it.

 

Take the deck out

 

Ground the mute wire

 

or T-tap the mute wire That you have relocated to the parking brake wire

 

[cookdiesel]

Thanks dub, got into it yesterday and the installer didn't even connect the mute wire.

 

Cut the end and grounded it with the parking brake wire and bingo! Everything up and working perfectly.

 

Thanks again.