Jump to content
AVIC411.com
jcrhunter

N3 new installation - display does not open

Recommended Posts

I purchased a used N3 a few years back from a seller on eBay who assured me it was working before he removed it prior to selling his car. For a number of reasons I never got around to installing it until this weekend.

 

When I powered it up for the first time I could toggle between the radio and Bluetooth phone modes but that's about it. The radio works fine using the tune up/down buttons but the display will not open so there's not much I can do with the unit other than listen to the radio. Pressing the display open/close button gets me a beep but not action, pressing it again gets another beep with a slightly different tone but still not action from the display, not even any noise from the motor.

 

Is this consistent with a broken GXX1257 flex cable or am I missing something obvious related to the unit being run for the first time after having been in storage for years? Is there any way I can manually pull open the display without breaking anything, if only to test the N3's many functions?

 

Thanks for any information you can provide.

 

Colin

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×