Specter

the voice file for destination on the LEFT/RIGHT is posted just above 1/2 way down the page. viewtopic.php?f=34&t=26699&p=185692&hilit=+left#p185692 HERE is a link to the actual voice file: download/file.php?id=7994

the voice file for destination on the LEFT/RIGHT is posted just above 1/2 way down the page. viewtopic.php?f=34&t=26699&p=185692&hilit=+left#p185692 HERE is a link to the actual voice file: download/file.php?id=7994

It does work to just add it to your sys.txt. I just usd this: [pioneer] parking_break_speed=255.0 No more warning about the brake sensor being miswired. Also, tried installing an IGO8 TTS package and had the same problem as someone else. It says UNDERSCORE DASH UNDERSCORE THE NEXT STREET.... Pretty useless that way.

You could always use the line below in your sys.txt. it will put the street names in a bubble like the screen below. it makes it easier to read. [3d_config] disable_roadsign_navigation_mode=0 It will look like normal when you start up igo. after you get a GPS signal or simulate a route it will put the street names in bubbles.

Yes, you will need all of those copied over from your original install. None of the maps, pois or buildings are included with the gurjon download.

Have you tried it with the gurjon sys.txt and your own ezrider.exe?

yes, it can be done. Needs the same code updates that are being added to the gurjon skin. On a side note: You can change the voices for the gurjon skin by changing them from the systems settings menu. Also, the TTS voices work! If you took my advice of deleting everything from the IGO directory before updating, you will have to copy the scansoft directory from your original install back into the igo directory. That should fix the TTS issues.

Try your original ezrider.exe file. I suspect the one in the gurjon package is the hacked version. I think there are issues with the hacked version and some Avics (from reading the hacked 3.0 thread). I had to add this to the sys.txt of the latest gurjon release to get the disply to show correctly. It was only showing the upper left hand corner of the screen until I added this. add to sys.txt if you have display problems. [rawdisplay] screen_x=800 screen_y=480 class="landscape" highres=0 dpi=250

Can confirm, reboots when you go to change the voices. I am using a non-TTS voice on an F500BT. It does now have audio with the supplied data.zip (on F500BT units). You don't have to use a generic data.zip anymore. Thanks again BorisM for posting these updates.

Thanks for the info BorisM. And thanks for sharing the Gurjon for avic. It is very nice! HERE IS A PICTURE OF IT:

Right here: viewtopic.php?f=34&t=26699

It is the Gurjon skin for avic. That is actually the time to destination on the bottom. check out www.gurjon.com to see screen shots. ...I like the street names in the bubbles, it makes it easier to read.

What do you need to add to the sys.txt to set up a 3D car model?

DELETED COMMENT.

If you add the line: disable_roadsign_navigation_mode=0 to your sys.txt it will put the street names in balloons over the street (like Amigo). It only shows that way when routing or you have a GPS signal. So when you first the GPS first starts up they will not be in balloons but when you simulate a route you can see what it looks like. It works good with roadsign_lines_per_screen=20. If you make the text too big it will not show in balloons but on the street. [3d_config] disable_roadsign_navigation_mode=0 roadsign_lines_per_screen=20 I don't know if this will work with Avic 2.0.