nuttzzy34 Posted October 19, 2008 Report Share Posted October 19, 2008 yesterday i was putting my z-1 in and i almost got it all the way back and it went dead. i figured i lost connection somewhere. checked all my connections there good. so i check all these fuses there all good. but the z-1 wont turn on. today im ganna check everything with my volt meter and make sure everything is egting power. any ideas what to keep my eyes open for while im in there? also... the blue wire, looking at the harness its the 4th wire from the right on the top. solid blue is this not the remote turn on? i could have sworn it was, i used to be the bomb at this and now im forgetting this stuff. strigthen me out!! Quote Link to post Share on other sites
garrettoomey Posted October 19, 2008 Report Share Posted October 19, 2008 Here is the pin out diagram for the back of the Z. This should help you identify the wire locations in the connectors. Quote Link to post Share on other sites
nuttzzy34 Posted October 19, 2008 Author Report Share Posted October 19, 2008 thank you very much sir... i dont wanna explain my stupid mistake. Quote Link to post Share on other sites
djmixmac Posted October 19, 2008 Report Share Posted October 19, 2008 Its pretty delicate back there. The harnesses can get scrunched or pinched or a wire can come out of the pin slot. Good luck and keep us posted! Quote Link to post Share on other sites
nuttzzy34 Posted October 20, 2008 Author Report Share Posted October 20, 2008 post i hooked it all up and nother worked i traced power all the way to the control box thing and no power is coming out of it at all. so i think that box is messed up. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.