dozug Posted January 21, 2009 Report Share Posted January 21, 2009 When i use navigation fuction, its really slow.. i mean i was turning the corner and the map is still on the straight line and after i made the turn compeletely, map shows im turning right now.. i almost have full signal,, Also, i can not access to the "Guide View" and "Route View" I didnt install them, I went to audio store and let them install.. I gues they forgot some wires.. Illumination is off(they didnt install) Also, every time i power on, thers pop up message saying Parking blake wire is installed incorrectly,,, so i have to push OK everytime it turns on.. Can you guys help me fixing all of them?? Thank you Quote Link to post Share on other sites
SDJASON Posted January 21, 2009 Report Share Posted January 21, 2009 Honestly, Bring it back and tell them to fix it. You paid them, make them do thier job. they most likely didnt install the VSS, illumination, and parking brake wires, and just left them there. Have you reset the learning on the unit?? is it mounted sideways or angled in your car? or is it level and perpendicular to the path of travel? ~Jason Quote Link to post Share on other sites
dozug Posted January 21, 2009 Author Report Share Posted January 21, 2009 Honestly, Bring it back and tell them to fix it. You paid them, make them do thier job. they most likely didnt install the VSS, illumination, and parking brake wires, and just left them there. Have you reset the learning on the unit?? is it mounted sideways or angled in your car? or is it level and perpendicular to the path of travel? ~Jason yes,, i will take them back,, but i just want to make sure what is missing.. they said they will fix them but yea,,, what is VSS?? Also what is learning on the unit?? I think mine is little bit tilted... not perpendicular to ground,, because my dash is tilted... is this causing some routing issue?? Thank you Jason Quote Link to post Share on other sites
BuffaloSS Posted January 24, 2009 Report Share Posted January 24, 2009 Have them tap into the VSS (Vehicle Speed Sensor) and your routing issues should go away. As far as the "relearn" goes, you need to get into NAV > "calibration settings" I believe, and find the learning mode/reset button. Quote Link to post Share on other sites
greyhd Posted January 25, 2009 Report Share Posted January 25, 2009 Sounds like they did not tap into the VSS wire and connect your brake wire. Take it back and have them do it right. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.