21polar Posted October 28, 2006 Report Share Posted October 28, 2006 I just recieved a New z1 back, after I sent the original one back because it had a backup camera issue. the old on (aug. build date)worked very good as far as the by pass goes, but now the newer one does not bypass at all. Does anyone have a solution to bypass the newer version?( I grounded one of the empty four spots in the connector as it was before, but it just keep telling me I hooked it up incorrectly) Thanks you for any help, and sorry if I missed a previous post on this. Quote Link to post Share on other sites
sportsfan21 Posted October 28, 2006 Report Share Posted October 28, 2006 Did you try resetting the unit? If you followed all the steps outlined here: [url=http://www.sminntech.com/z1flash.html]http://www.sminntech.com/z1flash.html[/url] you shouldn't have a problem, unless, of course, Pioneer changed the bypass again, which I doubt they did. Quote Link to post Share on other sites
21polar Posted October 28, 2006 Author Report Share Posted October 28, 2006 they sent me a Brand new unit , are you saying I should try resetting this one? Quote Link to post Share on other sites
sportsfan21 Posted October 29, 2006 Report Share Posted October 29, 2006 Yes. After you bypass it, try resetting it. Quote Link to post Share on other sites
ducatiboy Posted October 29, 2006 Report Share Posted October 29, 2006 You only need to reset the unit if you once tried to bypass the unit incorrectly by permanently grounding the parking brake wire. If you ever did than on a June or older unit, the flashing might not work. But if you used to have a June or older unit and replaced it and the new one isn't bypassed if your date is newer than that, you most likely need the 2 wire ground. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.