misiek Posted September 13, 2007 Report Share Posted September 13, 2007 so i just installed the pioneer nd-bc2 and everything seems to be working fine.... my only stupid question is should the whole screen be the camera shot because right now only 3/4 of my screen is the rear view shot and 1/4 is the map... is there a setting i have to change or something to make the rearview the entire screen like i see on the d3 or is that not an option on the d2? also how good is the nite vison on your camera..... i guess i was expeting more visibility at nite then i got... thanks Quote Link to post Share on other sites
whtcrxghst Posted September 13, 2007 Report Share Posted September 13, 2007 Hook up your reverse wire and it will be full screen when you put the car in reverse. My night vision is good, especially when braking Quote Link to post Share on other sites
misiek Posted September 13, 2007 Author Report Share Posted September 13, 2007 ok sounds good thanks would the reverse cable get hooked up to the lights or a switch? any suggestions would be great thanks Quote Link to post Share on other sites
HiFiSi Posted September 13, 2007 Report Share Posted September 13, 2007 You run the wire back to your tail lights and tap it in to the wire going to one of your reverse bulbs/lights. Quote Link to post Share on other sites
installthis06 Posted September 13, 2007 Report Share Posted September 13, 2007 You run the wire back to your tail lights and tap it in to the wire going to one of your reverse bulbs/lights. or find it in the wire harness on the drivers side, and test it with a meter. Saves a lot of time Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.