xxlikquidxx

I also encountered this problem numerous of time before and after updated to 3.0.1. Before from 2.0, it wouldn't connect maybe 4-5 times a month. Now with 3.0.1, it disconnect EVERY TIME i turn the car on... very annoying to say. Saving money right now for a Kenwood unit.....

how do i switch between 2D, 2D head up and 3D map? I keep tapping the compass icon but it wont response. I tapped the 2 green square on the upper right corner and it sometimes switch but not all the time. What is the proper way to do this ? Thanks alot!

bump anyone got the content of the iGo folder? I too was dumb enough to remove everything on My Flash Disk without backing up the very important folder... Now I cant access map, AV Source, some settings, etc... Please help!!!!

how exactly did you reinstall the APL folders? Please be more elaborate. I finally got a hold of the new 2.0 firmware. Tried to installed it like normal but seem like the unit wont read from my SD card at all with the new firmware in there. Tried on another SD card but it still wont read. Will tried the Testmode method tonight to see if i got any result... If not... Kenwood here i come.....

damn i just got this problem today too. When start up the car, my custom startup image load up for 10 seconds or so, then screen went black... Then lights around my knob slowly diminishing from bright colors to NONE.. the screen is black!!!! Sometimes if i hit the MAP button, the GPS would work but most of the time it doesnt. I tried all kind of reset methods from Pioneer but none of them work... haven't try reinstall the firmware again tho.. Can someone please post up the 2.0 firmware .zip package from Pioneer.com? I checked their site today but the server is down so I can

videos on my Ipod will work after waiting around 30 secs - 1 minute of the black screen after pressing the video file to play.

YES!! Thanks so much. You just save me a lot of time because its super hard to get to the e-brake location on my car. I will tap that line to the ground line on the main harness. Thank you so much

What do u mean by "Grounded"? I check the installation manual and it said to tap the light green brake wire to the "positive" line of the brake line and DID NOT mention anything about the ground wire or grounded?? Can you please help me clear that up? Should i follow the manual and tap to the power wire or the ground wire so it can be "grounded" like everyone here refer to? Thanks a lot. Also, what does the Yellow Mute wire connect to? I have done the relocation for it but it doesn't connect to anywhere on the other end? good or bad?

Hey, i just installed this unit and having the same exact problem.. The link you posted there to the forum for D3 hacks. Does that applies to the F700Bt as well? All i have done is performed the MUTE wire relocation per the hack forum for F-Series, which move it to a different location than the Avic-D3. Can i do the software bypass?