valkur

Do you have the reverse sensor wire grounded or connected to something? Maybe it thinks your stuck in reverse. Edit, re read your post and you said it wasn't, but that is what it sounds like.

This happened to me too, I had the IP bus cable plugged into the wrong port on the XM module. Switched it over, instant fix.

Copy your phone book in testmode to your card, open it with SQLlite and edit it the way you want then put it back into the unit. I used the posted method to use a cleaned up phonebook from my SE phone instead of the HUGE one on my iphone and it worked great.

apparently it turns off when you swap cards or usb dirves... ? It was working fine today but I didnt change any media so that must be it. Thanks.

Does anyone else find that when they set the random on USB/SD its gone the next time you turn on the vehicle? Is there a switch that can be turned on in one of the UIs?

Try calibrating your screen before rebooting to test mode then use the stylus. if you still cant hit the X, tap and hold on the blue bar and drag the window down and to the left to make clicking the x easier.

Iphone3g or SE w810i rings everytime, very loudly and i cant turn it down.

is your phone jailbroken out of curisoity? the 2.2 firmware upgrade came out this week and i may have to test it before i jailbreak again just to see.

Has anyone else had any luck with this problem? Im also using an iphone 3g, and it did this to me before and after the firmware updated. When i connect my old sony ericsson w810i the ringing volume is super loud, but turning it down (to mute) then back up one notch makes it acceptable, but the voice volume is cranked still. It seems like there should be a value that sets the volume, since it can be muted and turned up, would there be a file that sets the default bluetooth voice volume or scale that can just be lowered?