steve6534

In case anyone else searches in the future for systems using a PAC C2R-FRD1 or possibly other integration wiring modules see the attached tech note that was released. It explains the reason for unintended system resets along with a workaround - http://www.pac-audio.com/PACProductData/C2R-FRD1/3_Tech_Briefs/c2r-frd1_tech_bulletin_002.pdf

As long as you always have GPS signal it doesn't serve a purpose. If you do lose GPS (tall buildings, tunnels, etc) the VSS is used in conjunction with the internal gyro and compass to perform dead reckoning navigation.

The sirius tuner should be fine as I'm using the original SIR-PNR1. The ipod adapter isn't required with the 110 and the nav antenna and mic should work fine.

It sounds like your illumination wire isn't connected properly.

Interesting.. Did you use the relay to connect a higher power feed to the radio's accessory wire ? I occasionally have the same problem with a PAC controller but had an ammeter on the accessory wire to rule out too much current draw on the controller.

Is it possible to turn the additional screens on one at a time ? It sounds like one of them is causing a fair amount of rf noise and interfering with signal reception. If you happen to have access to a spectrum analyzer you could confirm.

What kind of car is this in ?

I installed the same setup in my '06 explorer and reused the factory satellite antenna for a cleaner look. The new sirius tuner was installed in the factory location (passenger side kick panel) and you just have to take the plastic cover off the end antenna cable to get it to fit. It snaps in 2 pieces so you can put it back to stock later if desired. I used the PAC C2R-FRD1 but the scosche looks to be identical - I wouldn't be surprised if the same manufacturer supplied both companies. I have a problem with my setup where turning the volume up loud with the sub enabled (with any music that has

Figured I would share if anyone was interested. Use promotion code VRCBKCX6 for 30% off. Works for most other Pioneer products as well.

Thanks DM ! I just placed an order as well for the same price.

As long as you have the remote and the non-touchscreen disc you can downgrade a unit with the newer version. The thread with instructions to do this can be found here - viewtopic.php?p=13060

So in other words he's interested in helping the modding community and not stealing? I'm good with that... Except that cracking an anti piracy key on a software upgrade has absolutely nothing to do with modding anything.

I guess I'm a little confused.. If you bought the upgrade why would you be downloading the same thing again ?

Searching for Pioneer IP Bus pinout brought it right up. Good luck - I imagine the IP Bus control plane is very proprietary ! http://www.hardwarebook.info/Pioneer_IP-Bus

I got mine but the receipt that was included in the box was from 6ave directly.