Jump to content
AVIC411.com

LOOSEWHEEL

Members
  • Content Count

    36
  • Joined

  • Last visited

About LOOSEWHEEL

  • Rank
    Member

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Cut paste the web link into Google. When the search responds back, click 'translate'
  2. ^^^^What he said ^^^^^....plus what I said 3 posts above that.
  3. Good stuff. Tried to find some icons for you but no luck. Keep at it. A lot of us are excited to see the finished product.................no pressure
  4. Everything you need is in this thread...>>>>>LINK<<<<. And I mean everything. Even when it doesn't work for you the 1st time, the solution will be in that thread.
  5. Why don't you try the FX3.1 upgrade. If your firmware is corrupt, this may fix it.
  6. http://thepiratebay.org/torrent/5546342
  7. 4 ohm for front and rear only. 2 ohm permissible on the sub channel.
  8. The 'resistor' fuse is simply a fuse that looks like a resistor. The color bands translate to the fuse value. These are also referred to as a 'pico' fuse. You can simply measure them to ensure they are a short to verify they are good. Last step would be to see if your getting the 12V at the harness connector that plugs into the HU. Verify no broken/bent pins in the connector at the harness and HU.
  9. I presume you are mixed up when you say you are measuring current. Just want to clarify that your DMM is set to read volts and not amps? Touching the resistor fuse with the meter set to volts will not damage it. Here is what to do. 1.Place car in reverse. 2.Place ground (black) lead to the same ground as your HU 3.Place positive (red) lead at the end of the resistor fuse that is attached to your reverse signal source. Should read ~12v 4.Place positive (red) lead at the end of the resistor fuse that is attached to your HU. Should read ~12V 5.Place positive (red) lead at the con
  10. Looking real good. Keep up the good work!
  11. Try the FX3.1 update. You have nothing to lose.
  12. Try the FX3.1 update again. Reread the thread to see the problems people have had. I found most would post a problem, then a couple posts later they resolved it as they did not follow instructions in the 1st place. Download the file again and follow instructions VERY carefully.
  13. Did you copy the 'CONTENTS' of MyFlash drive over rather than copying the MyFlash drive folder?? Or just do the FX3.1 upgrade.
  14. Fuses and resistors are bi-directional. It doesn't matter which way they go in.
  15. I am seeding it..............................
×
×
  • Create New...