wabadie

May be this will help http://www.coastaletech.com/gen6lockpick.htm

reset the speed pulse

First use the SD1 to update the bluetooth by manually going to the bluetooth settings to 3.10 then insert the SD2 to update the bluetooth to 3.22.

check the bypass according to the exact unit

Do you have the unit bypassed?

yes. When your idevices within the range just open the itunes and make sure wifi sync is enable.

yes. It is 5.0.1 and the ios 5.0 only works if the idevices plugged into the power source but the ios 5.0.1 doesn't need to be plugged into the power source.

I agree with that works only on ios 5.0.1

you need to upgrade it to z130 to use the new tuner

update the bluetooth ver 3.10 from sd1 then put the sd2 and do the bluetooth ver 3.22

Relay either I mean it's for the HID's or for the fog lights. Usually when you have a foglights switched on then if you flash it to the high beam foglights switch off by itself that means you have a relay on the foglights. Also some HID's have a direct connection which is plug n play but some of them connects through the relay.

Mostly it will interfere with the relay. I also have a Honda Accord with HIDs and Z110-120-130bt but I don't have a relay. So I never got that problem. Sometimes it's also interfere with the foglights

Do you have a HID's installed on your car? If you do yes some HID's does interfere with the HU

Yes I did works very good

Check the input and output on the bus cable,make sure it's black to black and blue to blue. I hope this will helps